About two months ago I decided it was time to upgrade my bandsaw. It took about a month to sell my old bandsaw and pull together the rest of the money for the new saw. In the middle of June I ordered a new Grizzly G0555P. That’s the Polar Bear version of Grizzly’s venerable G0555 Ultimate 14” Bandsaw in almost all white (the sides of the table are still Grizzly green).

At the same time I ordered the saw from Grizzly, I also ordered the 6” Riser Block Kit and the Heavy-Duty Mobile Base. And, I ordered 4 new 105” Timber Wolf bandsaw blades from Suffolk Machinery.  If you are a new customer, Suffolk has a Free Blade offer.

Read the rest of this entry »

Background

My current table saw, a Delta contractor saw, is my second.  The first one was a Ryobi portable table saw.  The user manuals from both manufactures suggested aligning the blade to the miter slot by pounding on the trunnion with a hammer or board or by prying on it with a board.  I tried these methods because I was a newbie and didn’t know of a better way.  While these methods produced barely adequate results, I was never really satisfied with it being close but not quite precisely aligned so I purchased a“> Contractor Saw Precision Alignment & Locking System (PALS™) almost two years ago.

Although I was not fully satisfied with the blade alignment on my table saw, I shied away from the task of installing the PALS™ kit because I thought it would be tedious and time consuming.  After all, my saw wasn’t way out of alignment. It was close enough to make reasonably accurate cuts.

But those extra blade marks on the sides of my rip cuts were a annoying and time consuming to clean up so before starting to build my materials cart, I decided to bite the bullet and tackle installing the PALS™ kit and doing a proper job of aligning my saw.

Product Details

Read the rest of this entry »